Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 GXP, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying CKP Sensor To Engine Block Retaining Bolt
    GM1949785Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (2) to the engine block.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the CKP sensor to engine block retaining bolt (1) and tighten to 10 N.m (89 lb in).
    3. Fig 2: Identifying CKP Electrical Connector
    GM1949783Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3) to the CKP sensor.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals