Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 6.0L, 6.2L - Introduction) >> Repair Instructions >> Spark Plug Wire Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Ignition Coil & Spark Plug Wire
    GM1950746Courtesy of GENERAL MOTORS CORP.
  1. Install the spark plug wire to the ignition coil (1).
  2. Install the spark plug wire (2) to the spark plug.
  3. Inspect the spark plug wire for proper installation:
    • Push sideways on each spark plug boot in order to inspect the seating.
    • Reinstall any loose spark plug boot.
  4. Install the engine cover. Refer to Engine Cover Replacement .
scientia non olet · About Mike's Workshop Manuals