Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 6.0L, 6.2L - Introduction) >> Repair Instructions >> Spark Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the engine cover. Refer to Engine Cover Replacement .
  2. Remove the spark plug wires. Refer to Spark Plug Wire Replacement .
    Fig 1: Locating Spark Plug Gap
    GM1950749Courtesy of GENERAL MOTORS CORP.
  3. Loosen each spark plug 1 or 2 turns.
  4. Use a brush, or use compressed air in order to remove any dirt from the spark plugs.
  5. Remove the spark plugs one at a time and place each plug in a tray marked with the corresponding cylinder numbers.
scientia non olet · About Mike's Workshop Manuals