Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Disc Brake System) >> Repair Instructions >> Rear Disc Brake Backing Plate Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Disc Brake Backing Plate To Knuckle Retaining Bolts
    GM1943438Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the disc brake backing plate (2) to the knuckle (1).
  2. Install the upper disc brake backing plate to knuckle retaining bolt (3).

    Tighten:  Tighten the bolts to 60 Nm (44 lb ft).

  3. Install the lower disc brake backing plate to knuckle retaining bolts (4).

    Tighten:  Tighten the bolts to 130 Nm (96 lb ft).

  4. Install the wheel hub. Refer to Rear Wheel Bearing and Hub Replacement .
  5. Install the wheel hub and knuckle assembly. Refer to Knuckle Replacement .
scientia non olet · About Mike's Workshop Manuals