Installation Procedure
WARNING: This page is about a different car, the 2011 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the digital radio antenna to the roof.
- Route the wiring pigtail to the side in the slot on the antenna shaft and install the antenna expansion sleeve (3) and bolt (2) to the antenna shaft.
Tighten
Tighten the bolt to 6 N.m (53 lb in).
- Connect the antenna connectors (1).
- Wrap the connectors (1) with foam tape.
- Install the antenna cable connection above the AM/FM antenna module.
- Install the antenna cable hold down clips.
- Install the headliner assembly. Refer to Headlining Trim Panel Replacement (With PLA) , Headlining Trim Panel Replacement (Without PLA) .
CAUTION:
Refer to Fastener Caution .