Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Anti-Lock Brake System, Traction Control System & Stability Control System) >> Repair Instructions >> Front Wheel Speed Sensor Wiring Harness Replacement >> Removal Procedure - Left

Removal Procedure - Left

WARNING: This page is about a different car, the 2008 Pontiac G8. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Safety Glasses Caution .
    CAUTION: Refer to Vehicle Lifting Caution .
    CAUTION: Refer to Brake Dust Caution .
    Fig 1: Identifying Wheel Speed Sensor Jumper Harness Electrical Connector
    GM1986529Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement , or Air Cleaner Assembly Replacement .
  2. Disconnect the wheel speed sensor jumper harness electrical connector (1).
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Remove the left hand front wheel. Refer to Tire and Wheel Removal and Installation .
    5. Fig 2: Identifying Wheel Speed Sensor Jumper Harness & Electrical Connector
    GM1943670Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the wheel speed sensor jumper harness electrical connector (1).
  6. Detach the wheel speed sensor jumper harness (3) from the brake hose/wheel speed sensor jumper harness bracket (4).
  7. Detach the wheel speed sensor jumper harness (3) from the front strut mounting bracket (2).
    8. IMPORTANT: Note the routing of the wheel speed sensor jumper harness (3).
  8. Remove the wheel speed sensor jumper harness (3) from the vehicle.
scientia non olet · About Mike's Workshop Manuals