Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Fixed And MOVEABLE Windows System) >> Repair Instructions >> Front Side Door Window Inner Weatherstrip Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Front Side Door Window Inner Weatherstrip
    GM1847490Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: It is Not necessary to remove the inner door trim panel.
    IMPORTANT: Install the weatherstrip/run channel by fitting both corners to the upper door frame and then pushing inward on the sides.
  1. Open the door.
  2. Lower the window to the full down position.
  3. Grasp the window weatherstrip in the center.

    Pull downward until the window weatherstrip fully releases from the door frame.

  4. Remove the window weatherstrip from the front door.
scientia non olet · About Mike's Workshop Manuals