Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 GXP, 4D Sedan >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 2.4L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAP Sensor
    GM1581050Courtesy of GENERAL MOTORS CORP.
  1. Install the MAP sensor with the port seal into the intake manifold.
  2. Connect the MAP sensor electrical connector.
  3. Install the throttle body. Refer to Throttle Body Assembly Replacement .
scientia non olet · About Mike's Workshop Manuals