Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 GXP, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 5 (Engine Control System & Fuel System - 2.4L - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor & Screws
    GM1581065Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the MAF/IAT sensor.
  2. Using a tamper proof TORX®, install the MAF/IAT sensor screws.

    Tighten:  Tighten the screws to 0.6 N.m (5 lb in).

    3. Fig 2: Identifying MAF/IAT sensor
    GM1578457Courtesy of GENERAL MOTORS CORP.
  3. Connect the MAF/IAT sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals