Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 8 (Engine Control System & Fuel System - 3.9L - Introduction) >> Repair Instructions >> Fuel Level Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Fuel Level Sensor & Electrical Connector
    GM1580741Courtesy of GENERAL MOTORS CORP.
  1. Carefully slide the fuel level sensor (2) into the slots on the fuel pump module bowl.
  2. Secure the retaining tab on the sensor into the slot on the pump module bowl.
  3. Connect the fuel level sensor electrical connector (1) to the pump module cover.
  4. Install the fuel level sensor electrical connector to the molded-in tab on the pump module bowl.
  5. Install the fuel sender. Refer to Fuel Tank Module Replacement .
scientia non olet · About Mike's Workshop Manuals