Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Mass Airflow Sensor with Intake Air Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor
    GM1837985Courtesy of GENERAL MOTORS CORP.
  1. Install a NEW MAF/IAT sensor seal.
  2. Install the MAF/IAT sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the MAF/IAT sensor screws and tighten to 4 N.m (35 lb in).
    4. Fig 2: View Of MAF/IAT Sensor Wiring Harness Connector
    GM1838957Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector to the MAF/IAT sensor.
  5. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
scientia non olet · About Mike's Workshop Manuals