Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Throttle Body
    GM1239002Courtesy of GENERAL MOTORS CORP.
  1. Install a new gasket, if necessary.
  2. Install the throttle body assembly.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the throttle body nuts and the bolts.

    Tighten:  Tighten the nuts and the bolts to 10 N.m (89 lb in).

    4. Fig 2: Identifying Heater Pipe Nut At Throttle Body
    GM1239021Courtesy of GENERAL MOTORS CORP.
  4. Install the heater pipe nut to the throttle body.

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

  5. Connect the ETC electrical connector.
  6. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  7. Perform the Throttle Learn Procedure. Refer to Throttle Learn .
scientia non olet · About Mike's Workshop Manuals