Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAP Sensor And MAP Sensor Seal
    GM1239001Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  3. Remove the MAP sensor attaching screw.
  4. Remove the MAP sensor and MAP sensor seal from the upper intake manifold.
scientia non olet · About Mike's Workshop Manuals