Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Exhaust Gas Recirculation Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EGR Pipe
    GM1239050Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the EGR pipe to the exhaust manifold.

    Tighten:  Tighten the EGR pipe bolts to 25 N.m (18 lb ft).

  2. Install the EGR pipe to the EGR valve.
  3. Install the EGR pipe bolt.

    Tighten:  Tighten the bolt to 30 N.m (22 lb ft).

scientia non olet · About Mike's Workshop Manuals