Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
CAUTION: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.
    Fig 1: Installing ECT Sensor
    GM1275978Courtesy of GENERAL MOTORS CORP.
  1. Partially drain the cooling system. Refer to Cooling System Draining and Filling (LY7, LZE, LZ4, LZ9) .
  2. Disconnect the engine coolant temperature (ECT) sensor electrical connector.
  3. Remove the ECT sensor.
scientia non olet · About Mike's Workshop Manuals