Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the O-ring with clean engine oil and replace the O-ring if damaged.
    2. Fig 1: View Of Camshaft Position Sensor
    GM909619Courtesy of GENERAL MOTORS CORP.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Connect the CMP sensor electrical connector.
scientia non olet · About Mike's Workshop Manuals