Installation Procedure

WARNING: This page is about a different car, the 2009 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Left Side Bracket Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to BATTERY DISCONNECT WARNING .

Install the four screws and the left side bracket.
Tighten: Tighten the four bracket screws to 3 N.m (27 lb in).

Fig 2: Identifying Right Side Bracket Screws

Courtesy of GENERAL MOTORS CORP.

Install the four screws and the right side bracket.
Tighten: Tighten the four bracket screws to 3 N.m (27 lb in).

Fig 3: View Of I/P Accessory Center Trim Plate, Radio & Fasteners

Courtesy of GENERAL MOTORS CORP.

Connect the following from the radio:
- The electrical connector
- The antenna lead
Install the radio to the instrument panel.
Install the 4 bolts which secure the radio.
Tighten: Tighten the four bolts to 13 N.m (10 lb ft).
Install the IP accessory center trim plate. Refer to Instrument Panel Center Trim Panel Replacement .