Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 1.8L (LV6) - Introduction (2 Of 2) >> Repair Instructions >> Engine Coolant Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: ECT Sensor And Electrical Connector
    GM641349Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
  1. Install the ECT sensor (2) into cylinder head.

    Tighten:  Tighten the ECT sensor to 20 N.m (14 lb ft).

  2. Connect the ECT sensor electrical connector (1).
  3. Refill the engine coolant. Refer to Cooling System Draining and Filling .
scientia non olet · About Mike's Workshop Manuals