Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 328 (Accessory Power Socket) >> Repair Instructions >> Power Outlet Receptacle Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accessory Power Receptacle Bezel Components
    GM853104Courtesy of GENERAL MOTORS CORP.
  1. Install the accessory power receptacle switch (5) to the bezel (3), by pushing in until the tabs lock in.
  2. Connect the electrical connector.
  3. Gently install the accessory power receptacle switch bezel (3) by pressing into place until the upper tabs (1) and lower tabs (4) are fully seated.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals