Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 264 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
    Fig 1: View Of Negative Battery Cable At Battery
    GM832902Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the accessory drive belt. Refer to Drive Belt Replacement - Accessory .
  3. Remove the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
  4. Disconnect the generator electrical connector.
    5. Fig 2: View Of Generator Cable & Nut
    GM395686Courtesy of GENERAL MOTORS CORP.
  5. Remove the generator cable from the generator, perform the following:
    1. Slide the boot down revealing the terminal stud.
    2. Remove the generator cable nut from the terminal stud.
    3. Remove the generator cable.
    6. Fig 3: View Of Generator & Bolts
    GM385810Courtesy of GENERAL MOTORS CORP.
  6. Remove the generator bolts.
  7. Remove the generator.
scientia non olet · About Mike's Workshop Manuals