Blower Motor Control Module Replacement

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Blower Motor Control Module Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the I/P insulator panel. Refer to Instrument Panel Insulator Panel Replacement . Disconnect the blower motor control module electrical connector.
1	Blower Motor Control Module Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 1.5 N.m (13 lb in)
2	Blower Motor Control Module

Callout

Component Name

Preliminary Procedure

Remove the I/P insulator panel. Refer to Instrument Panel Insulator Panel Replacement .
Disconnect the blower motor control module electrical connector.

Blower Motor Control Module Screw (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 1.5 N.m (13 lb in)

Blower Motor Control Module