Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System & Fuel System - 6.0L - Introduction (2 Of 2)) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Accelerator Pedal To Steering Column Support Bracket Retaining Bolts
    GM1950792Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal to the steering column support bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the accelerator pedal to steering column support bracket retaining bolts (2).

    Tighten:  Tighten the accelerator pedal mounting bolts to 20 N.m (15 lb ft).

  3. Connect the accelerator pedal sensor module electrical connector (1).
  4. Inspect for correct carpet fit under the accelerator pedal.
  5. If re-programming is required. Refer to Control Module References .
  6. Install the left I/P on the lower closeout insulator panel. Refer to Knee Bolster Replacement .
scientia non olet · About Mike's Workshop Manuals