Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Air Cleaner Inlet Duct Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Air Cleaner Duct To Intake Air Temperature (IAT)/Mass Air Flow (MAF) Sensor Retaining Clamp
    GM1949747Courtesy of GENERAL MOTORS CORP.
  1. Install the air cleaner intake duct (4) to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Tighten the air cleaner duct clamps.
  3. Install the air cleaner duct to throttle body retaining clamp (1).

    Tighten:  Tighten the air cleaner duct clamps to 4 N.m (35 lb in).

  4. Install the air cleaner duct to air cleaner assembly clamp (3)

    Tighten:  Tighten the air cleaner duct clamps to 4 N.m (35 lb in).

  5. Install the PCV hose (2) to the intake duct resonator.
scientia non olet · About Mike's Workshop Manuals