Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2008 >> G5 Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Inspect the CKP sensor O-ring and lubricate with a mineral based grease.
    2. Fig 1: View Of Crankshaft Position (CKP) Sensor
    GM770823Courtesy of GENERAL MOTORS CORP.
  2. Gently insert the CKP sensor into the block.
    3. NOTE: Refer to Fastener Notice.
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the CKP sensor bolt to 8 N.m (71 lb in).

  4. Reconnect the CKP sensor electrical connector.
  5. Install the starter. Refer to Starter Motor Replacement .
  6. Perform the CKP system Variation Learn Procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About Mike's Workshop Manuals