Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls & Fuel - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Locating Fuel Sender Access Panel
    GM65739Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (RPO LS4) or Battery Negative Cable Disconnection and Connection (RPOs L26/L32) .
  2. Remove the rear compartment trim panel. Refer to Rear Floor Trim Plate Replacement .
  3. Remove the nuts from the fuel sender access panel.
  4. Remove the fuel sender access panel.
    5. Fig 2: Fuel Pump & Sender Assembly Component View
    GM50636Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the fuel tank pressure sensor electrical connector.
  6. Remove the fuel tank pressure sensor (7) from the fuel sender assembly (1).
scientia non olet · About Mike's Workshop Manuals