Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G6 GTP, 4D Sedan >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of CKP Sensor
    GM1311144Courtesy of GENERAL MOTORS CORP.
  1. Install the crankshaft position sensor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the crankshaft position sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying CKP Sensor & Knock Sensor
    GM1839728Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (2) to the CKP sensor.
  4. Install the exhaust manifold lower heat shield. Refer to Exhaust Manifold Lower Heat Shield Replacement .
  5. Perform the Crankshaft Position System Variation Learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About Mike's Workshop Manuals