Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G6 Base, 3.5 N >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.5L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Lubricate the O-ring with clean engine oil before installation and replace the O-ring if necessary.
    2. Fig 1: View Of CKP Sensor
    GM15969Courtesy of GENERAL MOTORS CORP.
  2. Install the CKP sensor.
    3. NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

  4. Connect the CKP sensor electrical connector.
  5. Lower the vehicle.
  6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn .
scientia non olet · About Mike's Workshop Manuals