Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G6 Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position Sensor Replacement - Intake >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CMP Sensor
    GM1578483Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Inspect the CMP sensor for damage, replace as necessary.
  1. Lubricate the CMP sensor O-ring seal with clean engine oil.
  2. Install the CMP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying Intake & Exhaust CMP Sensor Electrical Connectors
    GM1578481Courtesy of GENERAL MOTORS CORP.
  4. Connect the intake CMP sensor electrical connector (1).
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About Mike's Workshop Manuals