Installation Procedure

Fig 1: View Of Ignition Switch Bracket

Courtesy of GENERAL MOTORS CORP.

Install the ignition switch bracket.
Install the theft deterrent control module. Refer to Theft Deterrent Module Replacement .

NOTE: Refer to Fastener Notice .

Install the ignition switch bracket screws.
Tighten: Tighten the screws to 5 N.m (44 lb in).

Fig 2: View Of Ignition Switch Assembly

Courtesy of GENERAL MOTORS CORP.

Install the ignition switch.
Tighten the ignition switch screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
Connect the park lock cable at the ignition switch. Refer to the appropriate procedure:
- Park Lock Cable Replacement for the 4T45-E transaxle
- Park Lock Cable Replacement for the 4T65-E transaxle
- Park Lock Cable Replacement for the 6T70/6T75 transmission
- Park Lock Cable Replacement for the F40 transmission
Install the theft deterrent module wire harness connector.
Install the ignition switch wire harness connector.
Install the ignition switch lock cylinder. Refer to Ignition Switch Lock Cylinder Replacement .
Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
Install the knee bolster. Refer to Knee Bolster Replacement .
Install the I/P cluster. Refer to Instrument Cluster Replacement .