Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G6 Base, 2.4 B >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Immobilizer System >> Diagnostic Information and Procedures >> DTC B3006 >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the hood ajar switch
  2. Ignition OFF, test for less than 5 ohms between the ground circuit terminal C and ground
    • If greater than the specified range, test the ground circuit for an open/high resistance
  3. Ignition ON, verify the scan tool Hood Ajar Sw. Signal 1 parameter is greater than 11 volts
    • If less than the specified range, test the signal circuit terminal A for a short to ground. If the circuit tests normal, replace the BCM
  4. Verify the scan tool Hood Ajar Sw. Signal 2 parameter is greater than 11 volts
    • If less than the specified range, test the signal circuit terminal B for a short to ground. If the circuit tests normal, replace the BCM
  5. Install a 3A fused jumper wire between the signal circuit terminal A and the ground circuit terminal C. Verify the scan tool Hood Ajar Sw. Signal 1 parameter is less than 1 volt
    • If greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM
  6. Install a 3A fused jumper wire between the signal circuit terminal B and the ground circuit terminal C. Verify the scan tool Hood Ajar Sw. Signal 2 parameter is less than 1 volt
    • If greater than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM
  7. If all circuits test normal, test or replace the hood ajar switch
scientia non olet · About Mike's Workshop Manuals