Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G5 Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE .
    IMPORTANT: The KS threaded surfaces must be clean before installation.
  1. Install the knock sensor.

    Tighten:  Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector.
  3. Install the starter. Refer to Starter Motor Replacement (RPO LSJ) or Starter Motor Replacement (RPOs L61/LE5) .
scientia non olet · About Mike's Workshop Manuals