Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2007 >> G5 Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Repair Instructions >> Wiper Drive System Module Replacement >> Installation Procedure

Installation Procedure

  1. Connect the electrical connector to the wiper motor.
    2. Fig 1: View Of Wiper Module Assembly
    GM1655547Courtesy of GENERAL MOTORS CORP.
  2. Install the wiper module assembly into the plenum.
    3. NOTE: Refer to Fastener Notice .
  3. Install the fasteners (1) attaching the wiper module assembly (2) to the plenum.

    Tighten:  Tighten the fasteners in sequence as shown to 10 N.m (89 lb in)

  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Install the wiper arms. Refer to Wiper Arm Replacement .
scientia non olet · About Mike's Workshop Manuals