Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 1.8L (LV6) - Introduction (2 Of 2) >> Repair Instructions >> Camshaft Position (CMP) Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: CMP Sensor, Hold-Down Bolt And Electrical Connector
    GM181686Courtesy of GENERAL MOTORS CORP.
  1. Install the CMP sensor (1) into the cylinder head.
    2. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the 1 CMP sensor hold-down bolt (2).

    Tighten:  Tighten the hold-down bolt to 9 N.m (80 lb in).

  3. Connect the CMP electrical connector (3).
    4. Fig 2: View Of Engine Top Cover, Plastic Retainers And Fasteners
    GM856569Courtesy of GENERAL MOTORS CORP.
  4. Install the engine cover (1).
  5. Secure the engine cover (1) with the 2 fasteners.

    Tighten:  Tighten the 2 fasteners to 8.8 N.m (77 lb in).

  6. Install the 2 plastic retainers.
scientia non olet · About Mike's Workshop Manuals