Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear (FWD) >> Installation Procedure

Installation Procedure

    Fig 1: Wheel Speed Sensor To Rear Wheel Hub
    GM840296Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the wheel speed sensor to rear wheel hub.
  2. Install the rear axle hub and bearing assembly. Refer to Wheel Bearing/Hub Replacement - Rear (FWD) or Wheel Bearing/Hub Replacement - Rear (AWD) in Rear Suspension.
    3. Fig 2: Wheel Cylinder Components
    GM829894Courtesy of GENERAL MOTORS CORP.
  3. Connect the wheel speed sensor electrical connector (6).
  4. Perform Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About Mike's Workshop Manuals