Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2006 >> Grand Prix Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.8L - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement (L32) >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Throttle Body Assembly (L32)
    GM911104Courtesy of GENERAL MOTORS CORP.
  1. Install the new gasket.
  2. Install the throttle body assembly (1).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the throttle body bolts (2) and the nuts (3).

    Tighten:  Tighten the bolts and the nuts to 10 N.m (89 lb in).

  4. Connect the throttle body electrical connector.
  5. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
  7. Fill the cooling system. Refer to Draining and Filling Cooling System (LS4 Static Fill) or Draining and Filling Cooling System (L26, L32 Static Fill) or Draining and Filling Cooling System (GE 47716 Fill) in Engine Cooling.
scientia non olet · About Mike's Workshop Manuals