Intrusive Test

DTCs P0050, P0059, P0101, P0102, P0103, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0125, P0128, P0151, P0152, P0153, P0154, P0155, P0201, P0202, P0203, P0204, P0205, P0206, P0220, P0222, P0223, P0442, P0443, P0446, P0449, P0451, P0452, P0453, P0454, P0455, P0461, P0464, P0496, P1153, P2119, P2135 are not set.
The Engine Run Time parameter is more than 6.5 minutes.
The ignition voltage is between 10-18 volts.
The Engine Speed parameter is between 2,500-3,000 RPM.
The MAF Sensor parameter is between 12-45 g/s.
The Vehicle Speed parameter is between 33-130 km/h (21-81 mph).
When all of the above conditions have been met for at least 2.5 seconds, the following conditions must also be met:
- The evaporative emission (EVAP) purge diagnostic is not active.
- The Short Term FT Bank 1 or the Short Term FT Bank 2 parameter is between +5 and -5 percent.
- The Loop Status parameter is closed.
- The EVAP purge solenoid is greater than 0 percent.