Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2006 >> G6 GTP, 2D Convertible >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.9L - Introduction (2 Of 2) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Electrical Connectors
    GM1582011Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  2. Disconnect the manifold absolute pressure (MAP) sensor electrical connector.
  3. Remove the spark plug wire clip from the intake manifold bracket, if necessary.
  4. Remove the MAP sensor bolt.
  5. Remove the MAP sensor.
  6. Remove the MAP sensor seal from the upper intake manifold.
scientia non olet · About Mike's Workshop Manuals