Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Sunfire Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Introduction & Repair Instructions >> Repair Instructions >> Vehicle Speed Sensor (VSS) Replacement >> Installation Procedure

Installation Procedure

  1. Clean and dry the vehicle speed sensor.
    2. Fig 1: Vehicle Speed Sensor (VSS) & Retaining Stud
    GM104524Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the vehicle speed sensor and the retaining stud.

    Tighten:  Tighten the stud to 12 N.m (97 lb in).

  3. Install the electrical connector at the sensor.
  4. Lower the vehicle.
  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About Mike's Workshop Manuals