Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Grand Prix Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.8L - Introduction >> Repair Instructions >> Barometric Pressure (BARO) Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Removing/Installing MAP & BARO Sensors Retaining Clips
    GM1210599Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (L26) or Fuel Injector Sight Shield Replacement (L32) in Engine Mechanical - 3.8L.
  2. Disconnect the BARO sensor electrical connector.
  3. Remove the BARO sensor retainer.
  4. Remove the BARO sensor.
scientia non olet · About Mike's Workshop Manuals