Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - 3.4L - Introduction >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying EVAP Canister & Purge Pipe
    GM670190Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister (3) on the EVAP canister bracket.
  2. Connect the EVAP hoses/pipes to the EVAP canister.
    3. Fig 2: Locating EVAP Canister Bracket Retaining Nut
    GM669530Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Position the EVAP canister and bracket on the fuel tank and install the 2 retaining nuts.

    Tighten:  Tighten the retaining nuts to 10 N.m (89 lb in).

  4. Install the fuel tank. Refer to Fuel Tank Replacement 
scientia non olet · About Mike's Workshop Manuals