Installation Procedure
- Install the transmission upper brace.
- Install the transmission upper brace bolts.
Tighten: Tighten the transmission upper brace outboard bolts (2) to 23 N.m (17 lb ft).
Tighten: Tighten the transmission upper brace inboard bolt (1) to 50 N.m (37 lb ft).
- Lower the vehicle or raise the powertrain until the frame insulators contact the chassis.
- Install the two frame rear bolts. Refer to Frame Replacement - Front (W/AWD) or Frame Replacement - Front (W/FWD) in Frame and Underbody.
- Connect the intermediate steering shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
- Install the transmission upper brace nut located behind the power steering pump.
Tighten: Tighten the transmission upper brace nut to 50 N.m (37 lb ft).
- Install the transmission lower brace.
- Install the transmission lower brace bolts.
Tighten: Tighten the transmission lower brace bolts to 50 N.m (37 lb ft).
- Install the transfer case brace. Refer to Support Brace Replacement (LA1) or Support Brace Replacement (LY7) in Transfer Case - Steyr.
- Install the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body Front End.
- Install the right front tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.