Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transaxle - Introduction & Repair Instructions >> Repair Instructions >> Transmission Fluid Pressure (TFP) Manual Valve Position Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of TFP Manual Valve Position Switch
    GM48220Courtesy of GENERAL MOTORS CORP.
  1. Carefully install the fluid pressure manual valve position switch. Handle the switch carefully, the fluid pressure manual valve position switch is very delicate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the control valve body bolts (375, 379 and 381) that mount the fluid pressure manual valve position switch to the control valve body (300).

    Tighten: 

    • Tighten the control valve body bolt (375) to 12 N.m (106 lb in).
    • Tighten the control valve body bolt (379) to 16 N.m (12 lb ft).
    • Tighten the control valve body bolt (381) to 8 N.m (70 lb in).

  3. Connect the transaxle wiring harness.
  4. Install the case side cover. Refer to Case Side Cover Replacement .
scientia non olet · About Mike's Workshop Manuals