Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Seat System) >> Repair Instructions >> Drive Cable Replacement - Vertical >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bolts.
    2. Fig 1: View Of Front Seat Bolts
    GM305124Courtesy of GENERAL MOTORS CORP.
  2. Tip the seat forward and disconnect the electrical connector from the seat electrical harness.
  3. Disengage the seat hook attachments from the floor pan.
  4. Tip the seat forward to expose the vertical drive cables (3 or 4).
  5. To remove either cable perform the following procedure:
    1. Bend the flexible cable at the center.
    2. Pull the cable out of the motor (1 or 2) and the drive screw.
    6. Fig 2: Vertical Drive Cable
    GM964716Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals