Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Shift Interlock System) >> Repair Instructions >> Automatic Transmission Shift Lock Actuator Replacement (Floor Shift) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the automatic shift lock actuator to the base of the shift lock control and the pivot point (1).
    2. Fig 1: Installing Automatic Shift Lock Actuator - Floor Shift
    GM442716Courtesy of GENERAL MOTORS CORP.
  2. Connect the automatic shift lock actuator electrical connector.
    3. Fig 2: Connecting Automatic Shift Lock Actuator Electrical Connector - Floor Shift
    GM190956Courtesy of GENERAL MOTORS CORP.
  3. Install the center console. Refer to Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gages and Console.
  4. Connect the negative battery cable. Refer toBattery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
scientia non olet · About Mike's Workshop Manuals