Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Hydraulic Brake System) >> Repair Instructions >> Master Cylinder Fluid Level Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connector from brake fluid level sensor.
  2. Remove the brake fluid level sensor. Using needle nose pliers, carefully depress the retaining tabs on the end of the brake fluid level sensor (1) and press the sensor through the reservoir to remove.
    3. Fig 1: Removing Brake Fluid Level Sensor
    GM176836Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals