Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Oil Pressure Test Plug Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the line pressure pipe plug.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the line pressure pipe plug (38).

    Tighten:  Tighten the plug to 12 N.m (106 lb in).

  3. Install the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement in Engine Controls - 3.4L or Air Cleaner Intake Duct Replacement in Engine Controls - 3.8L.
    4. Fig 1: View Of Line Pressure Pipe Plug
    GM164784Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals