Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Input Speed Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the case side cover. Refer to Case Side Cover Replacement .
  2. Disconnect the input speed sensor electrical connector.
  3. Remove the input speed sensor retaining clip (441).
  4. Remove the input speed sensor (440).
    5. Fig 1: View Of Input Speed Sensor
    GM48196Courtesy of GENERAL MOTORS CORP.
  5. Inspect the input speed sensor (440) for the following conditions:
    • Damaged or missing magnet
    • Damaged housing
    • Bent or missing electrical terminals
    • Damaged speed sensor clip (441)
    6. Fig 2: Inspecting Input Speed Sensor
    GM49299Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals