Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the Console Trim Plate. Refer to Trim Plate Replacement - Front Floor Console (Monte Carlo) or Trim Plate Replacement - Front Floor Console (Impala) or Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gauges and Console.
  2. Remove the console wiring harness.
  3. Remove the console shift control wiring harness.
    4. Fig 1: Removing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  4. Remove the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement .
  5. Remove the park/lock cable. Refer to Park Lock Cable Replacement .
  6. Disconnect the lightbulb and the retainer from the shifter.
  7. Remove the console shift control retaining nuts.
  8. Remove the console shift control assembly from the vehicle.
    9. Fig 2: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals