Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Automatic Transaxle - 4T65-E (Introduction, Service & Replacement)) >> Repair Instructions >> Floor Shift Control Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the console shift control into the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices
  2. Install the console shift control retaining nuts.

    Tighten:  Tighten the console shift control retaining nuts to 24 N.m (18 lb ft).

    3. Fig 1: Console Shift Control Assembly
    GM161200Courtesy of GENERAL MOTORS CORP.
  3. Install the park/lock cable. Refer to Park Lock Cable Replacement .
  4. Install the automatic transaxle range selector cable. Refer to Automatic Transmission Range Selector Cable Replacement .
  5. Install the console shift control wiring harness.
  6. Install the console wiring harness.
    7. Fig 2: Installing Console Shift Control Wiring Harness
    GM161196Courtesy of GENERAL MOTORS CORP.
  7. Install the console trim plate. Refer to Trim Plate Replacement - Front Floor Console (Monte Carlo) or Trim Plate Replacement - Front Floor Console (Impala) or Console Replacement - Front Floor (Impala) or Console Replacement - Front Floor (Monte Carlo) in Instrument Panel, Gauges and Console.
scientia non olet · About Mike's Workshop Manuals