Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Pontiac >> 2005 >> Aztek Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Front Suspension System) >> Repair Instructions >> Steering Knuckle Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the bearing/hub assembly. Refer to Wheel Bearing/Hub Replacement - Front .
  3. Remove the front lower control arm ball stud. Refer to Lower Control Arm Replacement .
  4. Remove the outer tie rod end from the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering.
    5. Fig 1: Scribing Strut To Knuckle
    GM385558Courtesy of GENERAL MOTORS CORP.
  5. Scribe the strut to the knuckle.
  6. Remove the bolts and nuts attaching the strut to the knuckle.
  7. Remove the knuckle from the vehicle.
    8. Fig 2: View Of Steering Knuckle To Strut Bolts
    GM385564Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Mike's Workshop Manuals